Find the line starting with "VP_PANA_model_ID" and write down the model. In the DCU / FactoryID folder, you will find the env_pana.txt file.Open the USB3 flash drive on the computer, enter VehicleParameter, DCU and the folder corresponding to the number from the previous step.Click "Model Information" and remember the DCU Part Number.You should be able to see the Audio 1011 version.Go to Settings> General> Software Update.When you see a blue screen saying success, turn the ignition switch off and on.Insert the flash drive into the car and perform the update again.Open the USB3 flash drive on your computer and delete the phaseup.dat file from it.Wait for half of the screen to turn green and hold the on / off button again to reset it again and go back to your normal home screen The device will return to the same screen.Hold the on / off button (volume knob) to reset the device.If the update was unsuccessful and you see a failure message that threatens to replace the radio, remove the pendrive from the radio. Below is a short tutorial on how I did it, for everyone who also has this problem: Okay, I made it despite the error while updating USB3. So today morning there was some news that a Polish club member had found a solution here : Software was updated (north view fixed, newer audio number etc), but no Carplay. I also prepared files on MAC choosing MS-DOS (FAT) believing it would not make much difference - because map updates have been OK before as well. Yesterday I was in the same position as You. So I as well gave up waiting and tried this retrofit(having free time is terrible).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |